IMAG0327

IteadStudio Prototype PCBs

Hack a Day had a post a while back involving a site called Dirt Cheap Dirty Boards offering (10) 5cm x 5cm boards for ~$15 shipped. I immediately wanted to test them out because that sounds like a pretty fair price. I tried to look into them a bit more, and after going through a few forums, it turned out that the site was made intending to be a joke (although they seem to actually be providing services now thanks to demand).

Despite them seeming like a non-option, I did a bit more research. There are a number of other fab shops that offer similar prices. The one that kept turning up in my search was IteadStudio, although others like OSHpark also showed up. IteadStudio had pretty good reviews though, and the prices were decent ($12 for 10 5×5 boards, and ~$3 shipping). I ended up deciding to go with IteadStudio and give them a try.

I don’t have too many Eagle boards designed just yet, because most of my stuff is breadboarded, so I only had a few options as far as what to send them. I ended up using the board layout for the Fireflies I posted earlier as well as a new board for noise makers (a device that can be hidden and beeps randomly). IteadStudio allows panelization of boards, so I managed to fit 3 Fireflies and 1 noise maker in the design, giving me 30 Fireflies and 10 noise makers overall. I submitted the order after adding a few misc electronic parts and got away spending less that $20 including shipping. That feels cheap enough that even if all I bought was crap, it wouldn’t be the end of the world.

Anyhow, about 3 1/2 weeks after I placed the order, I received the PCBs and parts in the mail. They did ship registered airmail so I needed to pick them from the post office after not being home to sign for the package. Once I had the package though, I opened it up and the PCBs looked like I would expect them too.

IMAG0327

They all seemed to have perfectly etched traces, silkscreen, solder mask, even the vias seemed fine. I hadn’t ordered PCBs before, so I wasn’t sure if vias would be included or extra. But, they all seemed pretty good, so I cut them out to their respective boards and soldered on all the necessary components.

IMAG0369

Then I programmed the microcontrollers for each. I found this connector for SOIC-8 packages on eBay for ~$10 and it makes programming this SMD package loads easier.

IMAG0373
IMAG0375

All said and done, I don’t think I found a defect on any of the boards. I’m absolutely impressed with the quality and will source PCBs from IteadStudio in the future for sure.

IMAG0253

Pineapple Habanero Salsa

Chips and salsa is always a good party snack. Some store bought salsas are pretty impressive, but making your own fresh salsa has no comparison. If you need to whip up one for a party try this recipe.

Ingredients:

  • Cilantro (half bunch)
  • 3 1/2 cups Petite diced tomatoes (~30 ounces)
  • 1 1/4 cups Crushed pineapple (~10 ounces)
  • 1/4 cup Diced onion
  • 1 to 2 Tbsp Crushed garlic or garlic powder
  • 1 1/2 Tbsp Habanero hot sauce / diced habaneros (or to taste)

Instructions:

  1. Mix diced tomatoes, onion, garlic, and pineapple in a bowl.
  2. Chop cilantro finely and add to bowl.
  3. Add Habanero to bowl and mix.
    Note: Start sparingly and increase to desired heat/spice level.
  4. Taste and serve.